Vehicles, Equipment, Tools, and Supplies |

O2 sensor fitting

FlowTech

Not Fitted / Universal

Part # 10120FLT | Line Code: FLT

Engine oil primer chev/pont

Mr Gasket

Not Fitted / Universal

Part # 3795G | Line Code: MRG

U/s exh gskt mat 6in. X 24in.

Mr Gasket

Not Fitted / Universal

Part # 5961 | Line Code: MRG

Belt installation tool

Gearwrench

Not Fitted / Universal

Part # 3684D | Line Code: KDT

Use with a breaker bar to loosen stubborn oxygen sensors. Tool comes with both 1

Use with a Breaker Bar to Loosen Stubborn Oxygen Sensors. Tool comes with both 1/2 and 3/8 drive. Attach a 1/2 breakerbar on the end of the tool to initially loosen stuck sensors. Usea 3/8 ratchet on the top for fast removal and installation. Fitsoxygen sensor applications with a heat shield. Slotted body allows clearance for wire harnesses. Forged, heat-treated steel with six point design will withstand high torque removal applications. *Made in Taiwan *inside hex: .878 - .885 *SIZE OF THE SOCKET IS 22mm or 7/8"

Not Fitted / Universal

Part # 12390 | Line Code: LIS

Small valve lapper 5/8 in. And 13/16 in.

Heavy duty rubber suction cups. Hardwood handle. Use with Lapping Compound (not included) to lap valves to match valve seats. Sizes: Small - 5/8 & 3/16".

Not Fitted / Universal

Part # W80570 | Line Code: PTL

High capacity v-belt (standard)

Roadmax

Not Fitted / Universal

Part # 15410AP | Line Code: GAT

High capacity v-belt (standard)

Roadmax

Not Fitted / Universal

Part # 15385AP | Line Code: GAT

Deluxe compression tester kit

Not Fitted / Universal

Part # W80584 | Line Code: PTL

10-piece fan clutch wrench tech kit

This set allows for easy removal of fan clutches when repairing or replacing water pumps, timing chains or fan clutch. Also useful when installing or removing engines, and for a variety of other engine service projects. Hold the fan clutch with the clutch holding tool while using the correct wrench to turn the fan clutch nut (Please note: Be sure to check your automobiles owner's manual for right or left hand thread). Square drives designed for use with a breaker bar for additional torque. For use on your Ford, GM or Chrysler. Parts included: 2 1/4 & 3 1/4" fan pulley holding tool. 2 3/8" fan clutch bolt holding tool. 2 1/8 & 3" fan clutch pulley holding tools. 2 13/16" fan hub wrench. 1 7/16" fan clutch nut wrench. 1 7/16" & 1 9/16" fan clutch wrench. 1 7/8" left hand clutch nut wrench.

Not Fitted / Universal

Part # W89400 | Line Code: PTL

Exh gskt; mtl 6 x 24

Mr Gasket

Not Fitted / Universal

Part # 77A | Line Code: MRG

Leak down test tech kit

Adjustable pressure regulator. 12mm and 14mm thread adapters. Helps identify causes of low cylinder compression.

Not Fitted / Universal

Part # W89729 | Line Code: PTL

Filter

Parts Catalog